TOP -> RENOVATE PARTS -> RENOVATE AERO
| BUMPER | BONNET | FENDER | LIGHT | AERO | GRILL |
Introduction of the repair process and the process of restoring and renovating recycled parts. |
|
1.Dent filling
|
|
2.Taping
|
|
3.Filling putty into hole and coat surrounding area with putty Sanding of the hole in the affected areas and the surrounding areas is done in order for the putty and substrate to adhere well. |
|
4.Filling gDEAL MIXh Putty is then poured into the area. |
|
5.gDEAL MIXh gDeal mixh putty is used for this process. |
|
6. Tape is removed from surface Tape applied previously is then removed from the surface. |
|
7.Sanding Paint on the affected and surrounding areas is then removed so that the surface base coat may be applied. |
|
8.Paper sanding The Aero is then paper-sanded with a fine sander and polished. |
|
9.Carbon fiber putty A carbon fiber putty is applied to strengthen the base coat. |
|
10.Putty
|
|
11.Poly-putty Finally putty (poly-putt) is applied on top of the carbon fiber putty to make sure of a smoother surface. |
|
12.Putty The affected area is then finished and polished by paper sanding. |
|
13.Green putty The repaired areas and surrounding areas are paper-sanded. |
|
14.Polishing The paper sanding process is finished and the product is polished. |
|
15.Finishing Once painted the Aero is placed in a filtered room to be blown with natural air. |
MAKER |
NISSAN |
|
NAME |
CIMA |
|
YEAR |
|
|
MODEL |
F50 |
MAKER |
TOYOTA |
|
NAME |
ALPHARDiMS-typej |
|
YEAR |
2002.5-2005.4@first |
|
MODEL |
MNH10 |
MAKER |
NISSAN |
|
NAME |
Skyline |
|
YEAR |
1998.5- |
|
MODEL |
R34 |
MAKER |
MAZDA |
|
NAME |
RX-7 |
|
YEAR |
|
|
MODEL |
FD3S |
MAKER |
TOYOTA |
|
NAME |
HARRIER |
|
YEAR |
2003.2- |
|
MODEL |
MCU30 |